Measuring the level of tower bottoms

In the atmospheric distillation process as well as in vacuum distillation, crude oil is separated into fractions by temperature. The least volatile components descend to the bottom of the column, where it is important to measure the liquid level in order to avoid excessive height or falling too low. If the level is too high, this could lead to tray damage and decrease the quality of the products with large impacts downstream in other units. If the level is too low, this could potentially damage pump seals or even the pumps themselves. With the radiometric level systems from Berthold the bottoms can be reliably measured in a non-invasive and non-intrusive manner, regardless of process conditions changes or environmental changes.

Customer benefits

  • Reliable prevention of pump cavitation
  • Increased efficiency of distillation process
  • Safe prevention of foam or liquid entering the upper fractions
  • Unaffected by foaming, plugging, build-ups or changes in temperature or pressure
  • Easy to install on existing columns without process downtime

Technical features

  • Continuous level measurement, typically 2 … 4 m measuring range
  • Installed on the cylindrical bottom of the column, mounted below all trays and packing
  • Redundancy can easily be provided
  • Typical arrangement: Cs-137 point sources and rod detectors
  • On small diameter columns Co-60 rod sources achieve best measurement results
  • As the source and detector are non-intrusive and non-invasive, they do not make contact with tarry tower bottoms, and are therefore not negatively impacted by the process buildups
  • SIL2 / SIL3 certified detectors available

Berthold has the best solution

Often, the level measurement on tower bottoms is carried out using differential pressure probes. Such devices require calibrations and often face issues with the plugging of pressure ports. Berthold offers a radiometric measurement solution, which does not have these issues and can easily be installed on existing columns without any process downtime. Typically an arrangement with a point source and a rod detector is applied here. In case of measurement ranges over 2 meters, our TowerSENS solution can be used to cover the entire span with just one set of wiring.

Downloads

4 Results